I finally tried a proper 2x72 grinder after using a 1x30 for three years, and the difference in finish on a Damascus chef's knife was like night and day.

The 2x72 let me hold a consistent angle and remove deep scratches in minutes, a job that took forever on the smaller belt and often left a wavy edge, so what's the best upgrade path for a home shop on a tight budget?

3 comments

3 Comments

sean_miller8813d ago

Man, that jump from a 1x30 is insane, right? I made the same switch last year and it felt like cheating. My old grinder would fight me on every bevel, but the 2x72 just makes everything so smooth and fast. For a budget upgrade, I'd look for a used motor and build the frame yourself, it saved me a ton of cash.

hart.mark13d ago

Check local machine shops for a used motor and scrapyard steel to build your own frame.

mila_perry133d ago

Guess my garage is about to become a budget machine shop... hope the neighbors don't mind the noise.