Scored a $30 dresser off the curb in Fort Wayne but a drawer came apart on the way home
I was driving back from my sister's place in Fort Wayne around 7pm when I spotted this wood dresser sitting by the curb with a free sign taped on it. I pulled over, checked it quick, and it looked solid enough, so I wrestled it into the back of my hatchback with the seats down. About two blocks from my house I hit a pothole and heard this crack, and one of the bottom drawers had popped its back panel loose. I got it home, pulled that drawer out, and saw it was just thin plywood held on with tiny staples that had rusted out. I ran to the hardware store before they closed and spent $6 on a small pack of wood screws and some glue, then cut a couple of thin strips from a scrap board I had in the garage to brace the back. Let it sit overnight and the drawer slides smoother now than the other two. Would I trust it to hold anything heavy? Not a chance. But it holds socks and t-shirts fine. Curious if anyone else here has a go-to fix for flimsy drawer bottoms, since I've got two more of these waiting on me.
Wait, $6 at the hardware store? That's it? I spend more than that on coffee in two days and here you are bringing a whole dresser back from the dead. The part that gets me is the rusty staples though, like the factory thought staples were gonna hold a drawer bottom forever. I've had good luck gluing a thin strip of wood across the bottom edge and screwing up through it into the sides, gives the plywood something real to sit on. For the two you got left, you might as well fix them before they fail on you instead of after. How thick is the plywood on those other drawers, is it the same flimsy stuff?