Serious question, did I waste $65 on a bearing press kit that flexes?
I picked up a cheap bearing press kit off a marketplace listing in Portland about 2 months ago for $65, thinking I'd save money over the name brand one my old shop had. Third set of pivot bearings I did with it, the drift rod bent just enough that the bearing went in crooked and gouged the frame. That was a $40 bearing and a customer who now thinks I'm a hack. I also spent a good 45 minutes trying to tap the bearing back out without wrecking the bore, which is time I didn't bill anyone for. So between the kit, the ruined bearing, and the lost hour, I'm out around $120 and I still don't trust the tool on anything carbon. Now I'm sitting here wondering if the flex is my fault for cranking too hard or if these cheap kits are all like this. Anyone running a press that actually holds straight without dropping $300 on the real thing?